Mountaineer V8-302 5.0L VIN P EFI (1998)
Camshaft Position Sensor: Service and Repair
Synchronizer
REMOVAL
CAUTION:
-
Prior to the removal of the Camshaft Position sensor (CMP sensor), set the No. 1 cylinder to Top Dead Center (TDC) of compression stroke.
Then note the position of the CMP sensor electrical connector. Installation procedures require that the electrical connector be located in the same
position.
-
Once the engine is aligned at TDC, do not move the crankshaft until the entire procedure is complete. Doing so will result in the fuel system being
out of time with the engine, causing a possible emissions fault.
1. Disconnect the battery ground cable.
CAUTION: Always disconnect the battery ground cable prior to working on the electronic engine controls or damage to the electronic
component may occur.
2. Remove the camshaft position sensor.
1
Disconnect the CMP sensor electrical connector.
2
Remove the screws.
3
Remove the CMP sensor.
3. Remove the (A) bolt and (B) clamp.
