Mountaineer V8-302 5.0L VIN P EFI (1998)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the Camshaft Position (CMP) sensor.
1
Disconnect the CMP electrical connector.
2
Remove the screws.
3
Remove the CMP sensor.
INSTALLATION
CAUTION: Make sure that the CMP sensor is properly positioned.
1. Install the CMP sensor.
1
Position the CMP sensor.
2
Install the screws.
3
Connect the CMP electrical connector.
2. Connect the battery ground cable.