Mountaineer V8-302 5.0L VIN P EFI (1998)
Spark Plug: Service and Repair
REMOVAL
1. Use the Spark Plug Wire Remover to pull the ignition wire off of the sparkplug with a twisting, pulling motion.
CAUTION: The spark plug wires must be connected properly. Mark the spark plug wires before removing them from the spark plugs.
NOTE: Spark plug heat shields on No. 4 and No. 8 cylinders are removable.
2. Remove the LH spark plugs.
NOTE:
-
Use compressed air to remove any debris from the spark plug well before removing the spark plugs.
-
If an original spark plug is reused, make sure it is installed in the same cylinder it was taken from. Replacement spark plugs can be used in
any cylinder.
3. Remove the RH spark plugs.
NOTE:
