Mountaineer V8-302 5.0L VIN P EFI (1998)
Hazard Warning Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable
2. Remove the ignition switch lock cylinder.
(1) Insert the ignition key into the ignition switch lock cylinder and turn to RUN position.
(2) Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. If equipped. twist the tilt wheel handle and shank counterclockwise and remove.
4. Remove the upper and lower steering column shrouds.
(1) Remove the screws.
(2) Remove the upper and lower steering column shrouds.
