Mountaineer V8-302 5.0L VIN P EFI (1998)
7. Connect the molded lead frame to the sensor.
-
Connect the bulkhead connector.
-
Connect the Electronic Pressure Control (EPC).
-
Connect the Torque Converter Clutch (TCC).
-
Connect the shift solenoid SSA/SS1 and SSB/SS2.
8. CAUTION: If installing a new filter, and the grommet remains in the main control bore, carefully use a small screwdriver to remove the
grommet. Use care not to damage the main control bore.
NOTE: If transmission is being serviced for a contamination-related failure, use a new filter and seal.
Replace fluid filter and seal as required.
9. Position the (B) pan magnet into the (A) transmission fluid pan.
10. NOTE: The pan gasket is reusable, clean and inspect for damage; if not damaged, the gasket should be reused.
