Mountaineer V8-302 5.0L VIN P EFI (1998)
4. Turn the differential ring gear without turning the pinion gear. Record the measurement.
-
The backlash tolerance is 0.13 mm ( 0.005 in) to 0.20 mm ( 0.008 in) and cannot vary more than 0.05 mm ( 0.002 in) between points
checked. A backlash variation of more than 0.005 mm ( 0.002 in) indicates gear/case runout.
-
If the backlash is not within specification, correct by increasing the thickness of one differential bearing shim and decreasing the
thickness of the other differential bearing shim by the same amount.
43. Remove the special tools.
44. Check the gear tooth contact pattern.
45. Using the special tools, install the axle tube bearing.
46. Using the special tools, install the axle shaft oil seal.
