Mountaineer V8-302 5.0L VIN P EFI (1998)
1
Remove the four bolts and remove the universal joint spider retainers.
2
Disconnect the front driveshaft.
3
Position the front driveshaft aside.
4. Measure the pinion bearing preload.
-
Use a beam-type torque wrench to measure the torque required to maintain rotation of the pinion and record the measurement for reference
during installation.
5. Index mark the companion flange to the pinion stem.
6. Use Companion Flange Holding Tool and remove the pinion nut.
CAUTION: Before proceeding, place a drain pan under the axle housing.
NOTE: Inspect the companion flange for burrs and replace as necessary. Make sure that the surfaces of the companion flange have not been
damaged during removal. The end of the companion flange that contacts the bearing cone, the nut counterbore, and the seal surface must be
smooth and free of nicks.
