Mountaineer V8-302 5.0L VIN P EFI (1998)
Remove the driveshaft from the U-Joint Tool, and install the snap ring.
3. Repeat Steps 1 and 2 to install the opposite side of the driveshaft yoke.
4. Inspect the driveshaft slip yoke; replace if necessary.
5. Repeat Steps 1 and 2 to install the remaining new bearing cups, spider, driveshaft slip yoke, and the snap rings.
6. NOTE: Do not strike the bearings.
Check the U-joints for freedom of movement.
-
If binding, strike the yoke with a brass or plastic hammer.
7. Install the driveshaft.
