Mountaineer V8-302 5.0L VIN P EFI (1998)
9. Remove the inboard halfshaft boot from the shaft assembly.
10. Remove the two outboard boot clamps.
11. Remove the outboard halfshaft boot.
12. NOTE: If grease is contaminated, clean and inspect the joint for wear. If worn or damaged, install a new outboard CV joint and shaft assembly.
Inspect for contaminated grease.
Assembly
1. Pack the outboard CV joint with grease.
1
Use Ford High Temp Constant Velocity Joint Grease to fill the outboard CV joint.
2
Spread any remaining grease from the service kit evenly inside the outboard halfshaft boot.