Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
^
Stamped seatback frames can be identified by not having the tell-tale hole in the frame that is evident on the tubular seatback frame. See Figure 2.
For each type of seat, a different service kit is required. Kits are NOT interchangeable. See Figure 3.
^
Stamped Seatback - The kit consists of:
-
One (1) UPPER bolt with thread sealer patch (bolt A)
-
One (1)1-inch spacer (spacer A)
^
Tubular Seatback - The kit consists of:
-
One (1) UPPER bolt with thread sealer patch (bolt A)
-
One (1) LOWER bolt without thread sealer patch (bolt B)
-
One (1) 3/4-inch spacer (spacer B)
SERVICE PROCEDURE
FOR ALL AFFECTED VEHICLES
WARNING:
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIRBAG SUPPLEMENTAL RESTRAINT SYSTEM VEHICLE AND WHEN
WORKING NEAR AN AIR BAG MODULE. THIS WILL REDUCE THE RISK OF PERSONAL INJURY IN THE EVENT OF AN
ACCIDENTAL DEPLOYMENT.
WARNING:
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT USE ANY MEMORY SAVER DEVICES.
NOTE:
