Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
4. Install the seat cushion swing rods.
1
Position the swing rods.
NOTE: Make sure the ends of the swing rods are positioned beneath the listing wires at the rear of the seat cushion foam.
2
Install the hog rings.
5. Invert the seat cushion trim cover.
6. Connect the seat cushion trim cover J-clips.
7. Assemble the 6-way power front bucket seat. For additional information, refer to Seat-Front Bucket, 6-Way Power, Except Limited.
NOTE: Be sure to read and follow all air bag warnings in Seat-Front Bucket, 6-Way Power, Except Limited, Disassembly and Assembly.
8. Reactivate the supplemental restraint system. For additional information, refer to Air Bag Systems.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
9. Prove out the air bag system. For additional information, refer to Air Bag Systems.
10. Check the restraint system for proper operation.
Limited
DISASSEMBLY
WARNING:
-
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIR BAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN
ACCIDENTAL DEPLOYMENT.
-
AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE
GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN. WASH YOUR HANDS WITH SOAP AND WATER
AFTERWARD.
-
THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM VEHICLE
PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.
NOTE:
-
If a seat equipped with a seat mounted side airbag system is being serviced the airbag system must be deactivated per the deactivation procedure
contained in Air Bag Systems.
