Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
2. Install the camshaft synchronizer.
NOTE:
^
When installing the camshaft synchronizer into the cylinder block, make sure that the arrow on the special tool is pointing toward the rear of
the vehicle.
^
The synchronizer will rotate slightly as the synchronizer gear engages the camshaft gear. When the synchronizer is fully installed the arrow on
the special tool should point to the position of the electrical connector.
3. Position the clamp and install the bolt.
4. Remove the special tool.
5. Install the Camshaft Position (CMP) sensor.
6. Install the upper intake manifold.
