Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
3. Remove the camshaft synchronizer.
NOTE: The oil pump driveshaft might come out with the camshaft synchronizer. If so, retrieve the oil pump drive shaft before proceeding.
INSTALLATION
CAUTION:
^
A special tool must be used during the installation of the replacement synchronizer assembly. Failure to follow this procedure will result in the fuel
system being out of time with the engine, possibly causing engine damage.
^
It is very important to coat the gear on the camshaft synchronizer with Super Premium SAE-5W-30 Motor Oil XO-5W30-DSP or equivalent
meeting Ford specification WSS-M2C153-G. Failure to do so could result in gear failure.
1. Install the special tool by rotating the tool until it engages the notch in the camshaft synchronizer housing and the armature.
