Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
14. Reattach the seat back trim cover lower J-clips.
15. Position the seat back to the seat bottom and route the wires and cables.
1
Pull the side air bag module wire harness through the seat bottom.
2
Pull the lumbar support cable through the seat bottom.
3
Pull the heated seat wire harness through the seat bottom.
16. Align the seat back to the seat bottom. Install the bolt and tighten to specification.
CAUTION: When positioning the seat or installing the bottom to the seat back, be careful not to damage the seat back pivot and any of the wires
or cables from the seat back to the seat bottom. This can cause damage to one of the seat components.
17. Install the two bolts and tighten to specification.
