Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
13. Through the seat backrest cushion opening, position the side air bag module aside.
^
Remove the retaining nuts.
NOTE: If installing a new side air bag module, use new retaining nuts. If the same side air bag module is to be reused, then reuse the side air bag
module retaining nuts.
14. Remove the side air bag module.
1
Release the side air bag module electrical connector clip.
2
Release the connector tabs by pushing in on them, then disconnect the side air bag module electrical connector.
3
Remove the side air bag module.
15. Remove the side air bag wiring harness.
^
Disconnect the pin-type retainers from the seat backrest frame.
NOTE:
