Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
9. If equipped, install the seat backrest trim cover swing rods.
1
Position the seat backrest trim cover and install the swing rods through the sleeves.
2
Install the hog rings.
NOTE: Make sure that the top of the swing rod is positioned beneath the listing wire near the middle row of hog rings.
10. Connect the hook and loop fastener to the seat backrest trim cover.
1
Pull the seat backrest trim cover completely down.
2
Reach up inside the seat backrest and grab the plastic above the hook and loop. Remove enough plastic to expose the hook and loop.
11. Hook the trim cover clip.
NOTE: If equipped, make sure that the seat backrest heating element wire is aligned with and off-set from the lower seat backrest trim cover
J-clip.
12. Assemble the seat. For additional information, refer to Seat-Front Bucket, 6-Way Power, Except Limited and Seat-Front Bucket, Limited.
NOTE: Be sure to read and follow all air bag warnings in Seat-Front Bucket, 6-Way Power, Except Limited and Seat-Front Bucket, Limited,
Disassembly and Assembly.
13. Reactivate the supplemental restraint system. For additional information, refer to Air Bag Systems.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
14. Prove out the air bag system. For additional information, refer to Air Bag Systems.
