Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
^
Remove the seat belt buckle from the vehicle. Refer to the service procedures in section 501-20A of the appropriate Workshop Manual.
^
Separate the seat belt buckle from the plastic anchor boot to access the build date code. If the plastic anchor boot is damaged during
separation, replace the seat belt buckle assembly regardless of the build date code.
3.
Compare the seat belt buckle date code to the code listed in the Build Date Code Inspection chart.
NOTE:
On certain vehicles, you will receive a retractor and buckle as an assembly. Only the buckle is to be replaced under this program. The retractor portion
of the new assembly should be discarded.
NOTE:
Apply Ford Threadlock 262 (E2FZ-19554B) or equivalent to fasteners when installing seat belt buckle assemblies.
^
If the build date code matches that listed in the chart, replace the seat belt buckle assembly. Refer to the service procedures in section 501-20A of
the appropriate Workshop Manual.
^
If the build date code does not match those listed in the chart, the seat belt buckle does not require replacement. Assemble and install the seat belt
buckle, if removed. Refer to the service procedures in section 501-20A of the appropriate Workshop Manual.
