Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
8. Disconnect the appropriate solenoid electrical connector.
1. Disconnect shift solenoids electrical connectors.
2. Disconnect the torque converter clutch (TCC) solenoid electrical connector.
3. Disconnect the electronic pressure control (EPC) solenoid electrical connector.
9. CAUTION: The TCC solenoid and converter modulator valve may pop out of its bore. This may damage the solenoid or converter modulator
valve.
CAUTION: Shift solenoid (SSC) may pop out of its bore. This may damage the solenoid.
Remove the shift solenoids.
1. Remove the wire harness.
2. Remove the solenoid clamp screws.
3. Remove the solenoid clamp.
4. Remove the appropriate solenoid(s).
Installation
1. Install the new solenoid(s).
