Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
1. Note: Before the installation of the clutch pedal shaft or clutch pedal, remove and inspect the brake and clutch pedal bushings. Clean and
lubricate with a light film of SAE 30 engine oil X0-30-BSD or equivalent ESE-M2C153-E and replace the brake and clutch pedal bushing if
excessive wear is evident.
Install the clutch/brake pedal assembly.
-
Install the clutch/brake pedal bushings and washers and the clutch pedal.
-
Install the clutch pedal shaft.
2. Install the retainer ring.
3. Install the clutch master cylinder push rod to pedal.
