Mountaineer 2WD V6-245 4.0L VIN X SFI (2000)
2. Install the ring gear bolts.
-
Apply Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSK-M2G349-AI to ring gear bolts.
3. With pinion depth set and pinion installed, place the differential case in the rear axle housing.
4. Install a shim on the left side.
5. CAUTION: Mark the position of the bearing caps as the arrows may not be visible. The bearing caps must be installed in their identical locations
and positions.
Note: Apply pressure toward the left side to make sure the left bearing cap is seated.
Install the left bearing cap and loosely install the bearing cap bolts.
