Mountaineer 2WD V6-4.0L VIN K (2007)
outboard recliner-to-backrest frame bolts.
3. Separate the kneeling mechanism release handle from the backrest frame.
-
Release the 3 kneeling mechanism release handle clips and separate from the backrest frame. Pull the kneeling mechanism release handle and
cable back through the backrest frame.
-
Separating the kneeling mechanism release handle from the backrest frame can also be done by going between the backrest foam pad and
backrest frame. Release the top and side clips and push out separating the kneeling mechanism release handle from the backrest frame.
4. Release the kneeling mechanism cable from the backrest frame.
5. Remove the 2 inboard and 2 outboard recliner-to-backrest frame bolts and remove the backrest assembly.
Installation
1. Remove 3 screws, recliner handle and outboard recliner outer cover.
2. Remove 2 screws and the inboard recliner outer cover.
3. WARNING: The recliner(s) are spring-loaded. Use care when seat back frame is removed and releasing the recliners from a backrest
upright position. The recliner upper arms will fold with significant speed/force. Failure to follow this instruction may result in personal
injury.
Position the inboard recliner pin to the recliner stop.
-
The recliner pin must contact the inboard recliner outer plate (stop).
4. WARNING: The recliner(s) are spring-loaded. Use care when seat back frame is removed and releasing the recliners from a backrest
upright position. The recliner upper arms will fold with significant speed/force. Failure to follow this instruction may result in personal
injury.
NOTE:
-
If the latch feet are not locked around the strikers on the mounting plate, the recliners will not lock in position.
