Mountaineer 2WD V6-4.0L VIN K (2007)
3. Remove all the staples holding the backrest trim cover to the backrest support panel.
4. Invert the seat backrest trim cover and foam pad to access the head restraint sleeve.
5. NOTE:
-
The inboard and outboard head restraint sleeves are not interchangeable.
-
The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
6. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat backrest foam pad.
Separate the hook-and-loop fasteners. Remove the seat backrest trim cover.
7. To install, reverse the removal procedure.
Seat Backrest Cover - Second Row, 60 Percent, Bench
SEAT BACKREST COVER - SECOND ROW, 60 PERCENT, BENCH