Mountaineer 2WD V6-4.0L VIN K (2007)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair
2. Remove the brake flow bolt and position the brake hose aside.
^
Discard the 2 copper washers.
3. Remove the 2 brake caliper guide pin bolts and remove the brake caliper.
4. Remove the brake pads from the brake caliper. Installation
1. Install the brake pads to the brake caliper.
2. Position the brake caliper and install the 2 guide pin brake caliper bolts.
^
Tighten to 32 Nm (24 ft. lbs.).
3. Using 2 new copper washers, position the brake hose and install the brake hose flow bolt.
^
Tighten to 35 Nm (26 ft. lbs.).
4. Bleed the brake caliper.
5. Test the brake system operation.
