Mountaineer 2WD V6-4.0L VIN K (2007)
17. Remove the 2 transmission-to-cylinder block cradle bolts.
18. NOTE: Cylinder block cradle is shown removed for clarity. Note the location of the 2 Torx(R) head bolts at the rear of the cylinder block cradle.
Remove the cylinder block cradle rear bolts.
19. Remove the 20 bolts and 2 nuts along the outside of the cylinder block cradle.
20. NOTE: Note the location of the 2 silver-colored bolts that have washer seals. They must be installed in the same position with new washer seals.
Remove the 8 cylinder block cradle inner bolts and the 2 washer seals.
^
Discard the washer seals.
21. Raise the engine.
AWD vehicles
22. WARNING: Secure the axle to the jack with a safety strap. Failure to follow these instructions may result in personal injury.
Support the front axle with a suitable jack stand.
23. Disconnect the vent hose from the differential housing vent tube.
24. Remove and discard the axle housing bolts and nuts. Lower the axle.
All vehicles
25. Remove the cylinder block cradle.
