Mountaineer 2WD V6-4.0L VIN K (2007)
Fluid Fill Reference
1. Using the scan tool, monitor the transmission fluid temperature (TFT) using PID: TFT.
2. Start the vehicle.
3. NOTE: Engine idle speed is approximately 650 rpm.
While proceeding with this procedure, run the engine until the transmission fluid temperature is between 27 - 49°C (80 - 120°F).
4. Move the range selector lever slowly through each gear, stopping in each position and allowing the transmission to engage.
5. Place the range selector lever in the PARK position.
6. With the engine running and the vehicle set as close to level as possible, position it on a hoist. For additional information, refer to Maintenance
/Service and Repair.
7. Hold the larger drain plug with a wrench and remove the small (center) fluid level indicating plug.
8. Install the special tool into the pan.
