Mountaineer 2WD V6-4.0L VIN K (2007)
fuel-related components. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions may result in
personal injury.
-
This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow
these instructions may result in personal injury.
CAUTION:
-
If the liquid or vapor tube is damaged (torn, holes or delaminated), a new tube assembly must be installed. Do not use aftermarket
sleeving. Do not re-adhere loose sleeving material.
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute cleanliness
is observed when working with these components. Always install blanking plugs to any open orifices or tubes.
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube. Apply clean engine oil to the end of the tube before inserting the tube into the
connector.
-
Do not use any tools. Use of tools may cause a deformity in the coupling components which can cause fuel leaks.
NOTE: During the repair or replacement of fuel-related components, all fuel liquid and fuel vapor openings shall be capped, taped or otherwise
appropriately protected to prevent the ingress of dirt or other contamination. All caps, tape and other protective materials shall be removed prior to
installation.
1. If servicing a liquid fuel tube, release the fuel system pressure.
2. Disconnect the battery ground cable.
3. Compress the clip legs and push the clip into the quick connect coupling.
4. Separate the quick connect coupling from the tube.
Connect - Type IV
1. Inspect the quick connect coupling and the tube for damage. Remove any dirt or obstructions.
2. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
