Mountaineer 2WD V6-4.0L VIN K (2007)
Ignition Coil: Service and Repair
IGNITION COIL
Exploded View
Removal and Installation
1. Disconnect the ignition coil electrical connector.
2. Disconnect the radio noise suppressor electrical connector.
3. NOTE: Spark plug wires must be connected to the correct ignition coil terminal.
Squeeze the tabs and twist, while pulling upward to disconnect the 6 spark plug wires from the ignition coil.
4. Remove the 4 bolts and the ignition coil.
-
To install, tighten to 6 Nm (53 lb-in).
5. NOTE: Apply silicone dielectric compound to the inside of the ignition coil boots.
To install, reverse the removal procedure.