Mountaineer 2WD V6-4.0L VIN K (2007)
Child Seat Tether Attachment: Service and Repair
Child Safety Seat Tether Anchor - Second Row
CHILD SAFETY SEAT TETHER ANCHOR - SECOND ROW
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should
be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
NOTE:
-
Second row bucket seats shown, others similar.
-
Carpet removed for clarity.
1. Remove the bolt(s) and tether anchor(s).
-
To install, tighten to 40 Nm (30 lb-ft).
2. NOTE: Sealant must be applied to the tether anchor bolts when installed.
To install, reverse the removal procedure.
