Mountaineer 2WD V6-4.0L VIN K (2007)
inspected according to the functional inspection procedures. Failure to install a new belt and retractor assembly could increase the risk of injury in
collisions.
1. Remove the rear quarter trim panel.
2. Remove the bolt and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the bolt and safety belt retractor anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
5. To install, reverse the removal procedure.
6. Check the active restraint system for correct operation.