Mountaineer 2WD V6-4.0L VIN K (2007)
4. Remove the screw and lift up to remove the fuel gauge sending unit.
Installation
1. Route the fuel gauge sending unit wire through the center of the fuel pump module.
2. NOTE:
-
Both fuel gauge sending wires must be routed behind the metal sending unit plate.
-
The grounding eyelet must be on the front side of the sending unit.
Hook the fuel gauge sending unit on the fuel pump module and install the screw through the grounding eyelet and tighten the screw.
3. Slide the heat shrink tube onto the wire harness and connect the electrical connector.