Mountaineer 2WD V6-4.0L VIN K (2007)
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
The LH and RH C-pillar mounted side impact sensors are not interchangeable.
1. Depower the system.
2. Remove the rear door scuff plate.
3. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
Remove the bolt and the safety belt anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Detach the upper C-pillar trim panel and position aside.
5. Position aside the quarter trim panel.
-
Pull out on the quarter trim panel at the C-pillar to release the retaining clips and access the C-pillar side impact sensor.
6. Disconnect the side impact sensor electrical connector.
7. WARNING: The tightening torque of the air bag side impact sensor retaining bolts is critical for correct system operation.
NOTE:
-
Note the position of the sensor and bracket locating tab for installation.
-
Make sure the C-pillar and side impact severity sensor mating surfaces are clean and free of foreign material.
Remove the 2 bolts and the side impact sensor and bracket assembly.
-
To install, tighten to 12 Nm (9 lb-ft).
8. To install, reverse the removal procedure.
9. Repower the system.
Front Door
SIDE IMPACT SENSOR - FRONT DOOR
