Mountaineer 2WD V6-4.0L VIN K (2007)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag SRS is involved in a collision,
inspect the sensor mounting bracket and wiring pigtail for deformation. Install a new sensor and correctly position the sensor or any
other damaged SRS components whether or not the air bag is deployed.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
Driver side shown, passenger side similar.
1. Depower the system.
2. Remove the front interior door trim panel.
3. Detach the rearward lower corner of the watershield on the door to expose the side impact sensor.
4. Disconnect the side impact sensor electrical connector.
5. WARNING: The tightening torque of the side impact sensor retaining bolt is critical for correct system operation.
CAUTION: The ground wire must be placed between the bolt head and the sensor. Never position the ground wire between the U-nut
