Mountaineer 2WD V6-4.0L VIN K (2007)
7.
Install new wiring harness by feeding wires through flange hole and inserting harness connector into flange until an audible click is heard. Check
for proper retention.
8.
Re-attach electrical connector harness to fuel pump housing. Prior to making the connection place one loop in the pump wires away from the
convoluted feed tube (Figure 4).
9.
Re-attach the signal wire (yellow) on the harness to the signal wire (yellow) on the replacement fuel level sensor assembly per WSM, Section
310-01 (Figure 5).
10.
Wrap the ground wire one time around the signal wire and attach the ground wire terminal to the terminal on the fuel level sensor assembly. Check
for proper retention.
NOTE
THE GROUND WIRE MUST BE WRAPPED AROUND THE SIGNAL WIRE, AS DESCRIBED IN STEP 10, TO PREVENT POTENTIAL
INTERFERENCE WITH THE FLOAT ROD ARM.
11.
Re-attach the fuel level sensor assembly to the fuel pump housing, making sure that both the signal wire and the ground wire are routed through the
