Mountaineer 2WD V6-4.0L VIN K (2007)
^
Remove and discard the Teflon(R) O-ring seal.
8. Remove the 3 bolts and the power steering pump.
Installation
1. NOTE: A new Teflon(R) O-ring seal must be installed.
Using the special tool, install a new Teflon(R) O-ring seal to the pressure line fitting.
2. Position the power steering pump and install the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.)
3. Connect the pressure line-to-pump fitting.
^
Tighten to 65 Nm (48 ft. lbs.)
4. Connect the reservoir-to-pump hose.
5. Install the power steering fluid reservoir-to-pump hose bracket bolt.
^
Tighten to 11 Nm (8 ft. lbs.)
6. Install the pressure line bracket-to-engine bolt.
^
Tighten to 11 Nm (8 ft. lbs.)
7. Install the power steering pump pulley.
8. Fill the power steering system.
