Mountaineer 2WD V6-4.0L VIN K (2007)
Wheel Bearing: Service and Repair
Front
Wheel Bearing and Wheel Hub
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can
result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the caliper, pads and anchor plate assembly aside.
^
Discard the bolts.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 165 Nm (122 ft. lbs.)
3. Remove the brake disc.
4. CAUTION: Inspect and if necessary, clean area around wheel speed sensor before removing it from the wheel bearing and hub.
