Mountaineer 2WD V6-4.0L VIN K (2007)
6. Remove and discard the 4 driveshaft flange bolts from the transmission output shaft flange.
^
To install, tighten to 112 Nm (83 ft. lbs.)
All vehicles
7. Remove and discard the 4 driveshaft flange bolts from the drive pinion flange.
^
To install, tighten to 112 Nm (83 ft. lbs.)
8. NOTE: Never hammer on the driveshaft, or any of its components, to disconnect the driveshaft flange from the differential pinion flange.
Using a suitable tool, pry only in the area shown to separate the driveshaft flange and the differential pinion or transmission output flange.
9. Slide the driveshaft toward the rear of the vehicle, while maneuvering the front section over the top of the vehicle frame crossmember.
10. To install, reverse the removal procedure.
