Mountaineer 2WD V6-4.0L VIN K (2007)
Drive/Propeller Shaft: Service and Repair
Driveshaft Slip Yoke Boot
Driveshaft Slip Yoke Boot
Special Tool(s)
Material
Removal
1. Remove the driveshaft.
2. Index-mark the driveshaft on both sides of the driveshaft slip yoke boot.
3. Remove and discard the driveshaft slip yoke boot clamps.
4. Separate the driveshaft. Remove the driveshaft slip yoke boot.
Installation
1. NOTE: Grease both ends of the driveshaft.
Position the driveshaft slip yoke boot and the driveshaft slip yoke boot clamps on one end of the driveshaft.
2. Align the index marks and connect the driveshaft.
