Mountaineer 2WD V6-4.0L VIN K (2007)
3
Spread any remaining grease evenly inside the boot.
4
Install the boot by seating it in the groove in the CV joint housing.
2. Using the special tool, install the boot clamps.
3. CAUTION: Install a new circlip every time the halfshaft is removed from the axle.
CAUTION: Start one end of the circlip in the groove and work the circlip over the halfshaft and into the groove to prevent the circlip
from overexpanding.
Install a new retainer circlip.
4. Remove and discard the inboard halfshaft excluder seal, if equipped.
5. For the inboard CV joint:
