Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
24. Disconnect the positive crankcase ventilation (PCV) hose, and the two PCV heater hoses.
25. Remove the upper intake manifold and discard the old gasket.
Installation
1. Note: Use Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification WSE-MSB392-A and a suitable plastic or wooden
scraper to clean the upper and lower intake manifold gasket surfaces.
Clean and inspect all surfaces, install new seals and gaskets.
2. Position the upper intake manifold and gasket and start the bolts.
3. Connect the two upper intake vacuum connections.
4. Connect the positive crankcase ventilation (PCV) tube, and the two PCV heater hoses.
5. Connect the vacuum supply line to the brake booster at the LH rear upper intake connection.
