Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
Dome Lamp: Service and Repair
Rear Domelamp Assembly
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the lamp assembly.
1
Use a thin bladed tool to carefully pry the lamp assembly to the left.
2
Press the locking tab inward.
3
Lower the lamp assembly.
4
Disconnect electrical connector.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
