Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
Steering Column Lock: Service and Repair
Ignition Switch Lock Cylinder
Functional Lock Cylinder
Removal
1. Disconnect the battery ground cable and wait at least one minute.
2. Remove the ignition switch lock cylinder.
1
Insert the ignition key and turn to the RUN position.
2
Press the ignition switch lock cylinder release pin while pulling out the ignition switch lock cylinder.
Installation
1. Follow the removal procedure in reverse order.
^
Verify ignition switch lock cylinder operation.
2. Prove out the air bag system.
Non-Functional Lock Cylinder
Removal
WARNING: Always wear safety glasses when repairing an air bag Supplemental Restraint System (SRS) vehicle and when handling an air
bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in
the event of an accidental deployment.
WARNING: Do not set a live air bag module down with the trim cover face down. This will reduce the risk of injury in the event of an
WARNING: After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that
is irritating to the skin. Wash your hands with soap and water afterwards.