Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal
injury.
WARNING: Air bag modules with discolored or damaged trim covers must be replaced, not repainted.
WARNING: Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag Supplemental Restraint
System (SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly
position the sensor or any other damaged Supplemental Restraint System (SRS) components whether or not the air bag is deployed.
WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or
replacing any front or side air bag Supplemental Restraint System (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
The side air bag sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).
1. Disconnect the battery ground cable and wait at least one minute.
2. Remove the steering wheel.
3. Twist off the cap from the ignition switch lock cylinder.
4. Remove the ignition switch lock cylinder.
^
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
^
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
^
Remove and discard the ignition switch lock cylinder and drill shavings from the steering column.
