Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
Seals and Gaskets: Service and Repair
Extension Housing Seal, A/T
Special Tools
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Drain the transmission fluid.
4. Note: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
Remove the rear driveshaft.
1. Remove the four bolts.
2. Remove the rear driveshaft.
5. Use High-Lift Jack to support the transmission.
6. Remove the nuts.