Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
13. Using the special tool, recheck the backlash.
-
If the backlash is within specification, go to Backlash within specification in this procedure. If the backlash is not within specification, repeat
measuring backlash in this procedure.
Backlash within specification
14. Remove the bearing caps and bolts.
-
To establish differential bearing preload, increase both left and right shim sizes by the specification shown in the illustration.
-
Using the special tool, make sure that the differential bearing shims are fully seated and the assembly turns freely.
15. Install the bearing caps and bearing cap bolts.
