Mountaineer 2WD V8-302 5.0L VIN P SFI (2000)
5. Install the (RH) transmission mount bolt.
1. Position the exhaust bracket.
2. Install the bolt.
6. install the crossmember.
1. Position the crossmember.
2. Install the six bolts and nuts (three each side).
7. Remove the Hi-Lift Jack.
8. Install the nuts.
9. Note: To maintain initial driveshaft balance, align marks on the rear driveshaft centering socket yoke and rear axle universal joint flange made
during removal.
Install the rear driveshaft.
1. Position the rear driveshaft.
2. Install the four bolts.
