Mountaineer 2WD V8-4.6L (2010)
Passenger seat with heat
12. Disconnect the backrest heated seat mat electrical connector and route out the wire harness.
-
Release any wire harness retainers.
All seats
13. Release the pin-type retainers, disconnect and route out the side air bag module electrical connector and wire harness.
14. NOTE: Driver shown, passenger similar.
Release the side air bag wire harness pin-type retainers across the back of the cushion frame.
15. Remove the 4 recliner-to-cushion frame bolts and remove the backrest assembly.
-
Route out the manual lumbar cable and any wire harnesses (if equipped).
-
To install, tighten to 55 Nm (41 lb-ft).
16. To install, reverse the removal procedure.
17. Install the front seat. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to Seat -
Front See: Service and Repair/Front Seat/Seat - Front.
Passenger seat
18. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. For additional information, refer to
General Procedures portion of Restraint Systems. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests and General
Diagnostics
Seat - Exploded View, Second Row
Seat - Exploded View, Second Row