Mountaineer 2WD V8-4.6L (2010)
56. Install the three seat track-to-floor bolt covers.
57. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
Position the safety belt anchor onto the seat and install the anchor bolt. Tighten to 40 Nm (30 lb-ft).
58. Install the safety belt anchor bolt cover.
59. NOTE: DO NOT prove out the SRS for the passenger seat until the Occupant Classification Sensor (OCS) System Zero Seat Weight Test has been
completed.
Repower the Supplemental Restraint System (SRS). For additional information refer to the WSM Section 501 20B SRS Repowering Procedure.
Passenger Seat Only
60. Perform the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. For additional information refer to the
WSM Section 501-20B.