Mountaineer 2WD V8-4.6L (2010)
9. With power seat track, remove the seat control switch knob and separate the seat control switch from the cushion side shield.
-
Remove the cushion side shield.
Power seat
6. Separate the seat control switch wire harness pin-type retainer from the cushion frame.
Driver seat
7. Disconnect the SRS seat position sensor.
8. Driver seat with 10-way power, disconnect the backrest power feed electrical connector and route out the wire harness.
-
Release any wire harness retainers.
Heated seat
9. NOTE: Passenger shown, driver similar.
Disconnect the cushion and backrest heated seat mat electrical connectors.
All seats
10. Release the pin-type retainers, disconnect and route out the side air bag module electrical connector and wire harness.
11. Remove the safety belt buckle and pretensioner electrical connector cover.
12. Disconnect the safety belt buckle and pretensioner electrical connector and safety belt buckle switch electrical connector.
13. Release all the cushion trim cover retainers.
14. Remove the seat cushion foam pad and cushion trim cover.
