Mountaineer 2WD V8-4.6L (2010)
15. Remove the 4 cushion frame-to-seat track nuts and the seat track.
-
To install, tighten to 36 Nm (27 lb-ft).
Driver seat with failed horizontal motor
16. If necessary, remove the inboard horizontal screw block bolt. This will allow the inboard power seat track to move independently so the safety belt
buckle and pretensioner can be removed.
All seats
17. To install, reverse the removal procedure.
18. Install the front seat. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to Seat -
Front See: Service and Repair/Front Seat/Seat - Front.
Passenger seat
19. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. For additional information, refer to
General Procedures portion of Restraint Systems. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests and General
Diagnostics
