Mountaineer 2WD V8-4.6L (2010)
Truck Bed Storage Compartment Handle: Service and Repair
Pickup Bed Storage Compartment Release Handle
Removal and Installation
1. Remove the 2 pickup bed storage compartment release handle bolts.
-
To install, tighten to 12 Nm (106 lb-in).
2. NOTICE: Do not allow the pickup bed storage compartment lid to close until the latch has been connected to the cable. If the lid is closed
prior to attaching the cable to the latch, releasing the latch is extremely difficult.
Remove the pickup bed storage compartment latch. For additional information, refer to Pickup Bed Storage Compartment Latch See: Truck Bed
Storage Compartment Latch/Service and Repair.
3. NOTE: Note the routing of the pickup bed storage compartment release cable.
Release the routing clips and remove the pickup bed storage compartment release handle and cable as an assembly.
4. To install, reverse the removal procedures.